Application Tips

The following comments are general in nature.

Successful application of a transfer is the result of having the correct TIME, PRESSURE and TEMPERATURE. Generally, when applying a transfer there are minimum requirements for each product which must be met. Please follow these guidelines for a successful print every time.

1) Always pre-heat the garment by lowering the heat platen on to the garment for a couple of seconds. This is necessary since many types of fabric tend to shrink slightly when heat is applied. Pre-heating the garment helps to avoid a 'blurred' effect in the print.

2) Check your heat seal machine temperature regularly using thermo-tape strips.

3) Pre-test transfers on scrap fabric whenever possible.

4) When printing 'mesh' shirts use a teflon slip sheet between the layers of fabric or slide the shirts over and under the base pad, with a teflon sheet taped to the base pad.

5) Reduce pressure when printing light coloured inks on dark coloured fabric to avoid colour being lost into the fabric.

6) In some cases when applying cold peel cap transfers, the transfer tends to lift on the corners.To avoid this rub the transfer or hold it down with a cloth for a few seconds after lifting the platen.

7) Whenever a teflon sheet is placed over a print during application, add 10 degrees or 2 seconds to the otherwise recommended settings.

8) It is a good habit to make a list of the various materials which are commonly used in your cresting department and make a note of the time and pressure required for each.

9) Washing Instructions - Turn garment inside out. Use mild detergent. Lay flat to dry. Do not bleach. Do not dry clean. Do not use an iron directly on print / crest.